Shirt inspection
1. Appearance inspection:
-Roving, running yarn, flying yarn, dark horizontal lines, white marks, damage, color difference, stains
2. Dimensional inspection: Strictly follow the size chart.
3. Symmetry test:
-The size of the collar tip and whether the collar bones are relative;
-The width of the two arms and the two circles;
-The length of both sleeves, the width of the cuffs, the distance between the sleeve pleats, the length of the sleeve forks, and
the height of the sleeves;
-The height of both sides of the pole;
-Pocket size, height;
-The placket is long and short, and the left and right strips are symmetrical.
4. Workmanship inspection:
- The lines in each part should be straight and tight, and there should be no floating threads, jumpers, or broken threads.
The splice threads should not be too many and should not appear in conspicuous positions. The stitch length should not be
too sparse or too dense, in accordance with the regulations;
- The collar tip should be close to the collar, the collar surface should not be bulging, the collar tip should not be broken, and
there should be no regurgitation at the mouth. Pay attention to whether the bottom line of the collar is exposed, the seam
should be neat, the collar surface should be tight and not curled up, and the bottom of the collar should not be exposed;
-The placket should be straight and flat, the side seams should be straight, the elasticity should be appropriate, and the width
should be consistent;
- The inner stop of the open bag should be cut cleanly, the bag mouth should be straight, the bag corners should be rounded,
and the seal should be consistent in size and firm;
-The hem of the shirt should not be twisted and turned outwards, the right-angled hem should be straight, and the round
bottom hem should have the same angle;
-The upper thread and bottom thread should be appropriately tight to avoid wrinkling (parts prone to wrinkling include collar
edges, plackets, clip rings, sleeve bottoms, side bones, sleeve forks, etc.);
- The upper collar and embedded clips should be arranged evenly to avoid too much space (the main parts are: collar nest,
cuffs, clip rings, etc.);
- The positioning of the button door must be accurate, the incision must be clean and hairless, the size should match the
button, the button position must be accurate "especially the collar tip", and the button line should not be too loose or
too long;
-The thickness, length and position of the jujubes must meet the requirements;
-The main parts of the strips and grids: the left and right panels are opposite to the placket, the bag piece is opposite to the
shirt piece, the front and rear panels are opposite, the left and right collar tips, sleeve pieces and sleeve forks are opposite;
-The rough and reverse rough surfaces of all parts are consistent in the same direction.
5. Ironing inspection:
- The clothes are ironed and flat, without yellowing, defects, water stains, dirt, etc.;
- Ironing important parts: collar, sleeves, placket;
-Threads must be completely removed;
-Pay attention to Pak penetrating glue.
Please contact CIT for details and we will create a one-stop service for you to ensure your comfort and satisfaction.
